 |
 |
 |
|
|
 |
| MBD-PDSBA-Q+-O |
- PDSBA-Q+ (Standard Retail Pack)
|
| MBD-PDSBA-Q+-B |
|
| |
|
|
| Form Factor |
|
| Dimensions |
- 11.5" x 9.5 ", (29.2cm x 24.0cm)
|
| |
|
| CPU |
- Single LGA775 ZIF Socket
- Supports a Dual-Core Intel® Xeon® 3000 Series processor
- Supports an Intel® Core™2 Duo Series processor
- Supports a Dual-Core Intel® Pentium® D processor
- Supports an Intel® Pentium® 4 processor
- Supports an Intel® Celeron® D processor
- NOTE: This board DOES NOT support Q9000, E8000, E7000, E5000 series or 45nm processor
|
| System Bus |
- 1066 / 800 / 533 MHz system bus
|
| |
|
|
| Memory Capacity |
- Four 240-pin DIMM sockets
- Supports up to 8 GB of unbuffered, non-ECC DDR2 800/667/533MHz memory (Single / Dual Channel)
|
| Memory Type |
- DDR2 800/667/533MHz unbuffered, non-ECC SDRAM, 240-pin gold-plated DIMMs
|
| DIMM Sizes |
- 256 MB, 512 MB, 1 GB, 2 GB
|
| Memory Voltage |
|
| |
|
|
| Chipset |
- Intel Q965
- ICH8 + Intel® 82573L
|
| Serial ATA |
- Intel® ICH8 SATA (3Gbps) controller built-in
|
| Network Controllers |
- Intel® 82573L (Single Port) Gigabit PCI-Express Ethernet
- Supports 10BASE-T, 100/1000BASE-TX, RJ45 output
|
| Graphics |
- On-chip Intel GMA 3000 Graphics
|
| Audio |
- Realtek ALC883 7.1 channel HD audio
|
| Super I/O |
|
| Clock Generator |
|
| TPM |
|
| |
|
|
| Serial ATA |
- Four Serial ATA ports (3Gbps)
- Four SATA hard drives supported
|
| IDE |
- Two EIDE channel supports up to four UDMA IDE devices
- IDE Master / Slave 2 ports
- Supports UDMA Mode 5, PIO Mode 4, and ATA/100
|
| Floppy |
- 1 Floppy controller; 1.44 MB
|
| LAN |
|
| USB |
- 6x USB 2.0 compliant external ports
- 2x internal headers supporting up to 4 ports (USB 2.0 Compliant)
|
| VGA |
|
| Audio |
- 1x Line In / Front L & R / Center &
Sub-Woofer/ Surround L & R / Side Surround L & R / Line Out /
Microphone ports
|
| Keyboard / Mouse |
- PS/2 keyboard and mouse ports
|
| Serial Ports |
- 1x Fast UART 16550 serial port
- 1x Serial Header
|
| Parallel Port |
- 1x ECP / EEP Parallel Port
|
|
 |
|
|
|
| Important Note |
- To ensure system stability, a 450W (minimum) ATX power supply [4-pin +12V AND (20 or 24-pin)] is required.
|
| |
|
|
| PCI-Express |
- 1 (x16) PCI-e slot (intended for Graphics applications)
- 1 (x4) PCI-e slot (using a x8 physical slot)
- 1 (x1) PCI-e slot
|
| PCI |
- 3x 32-bit 33MHz PCI (5V) slots
|
| |
|
|
| BIOS Type |
- 8Mb Flash EEPROM with Phoenix BIOS®
|
| BIOS Features |
- Plug and Play (PnP)
- DMI 2.3 support
- PCI 2.2
- ACPI 1.0 (limited)
- USB Keyboard support
- SMBIOS 2.3
|
| |
|
|
| Software |
|
| Power Configurations |
- ACPI Power Management
- Main Switch Override Mechanism
- Wake-On-Ring (WOR) header
- Wake-On-LAN (WOL) header
- Keyboard Wakeup from Soft-Off
- Suspend to RAM (STR)
- Power-on mode control for AC power loss recovery
- Internal/External modem remote ring-on
|
| |
|
|
| Voltage |
- Monitors for CPU Cores, +1.8V, +3.3V, +5V, ±12V, +3.3V/+5V Standby, VBAT
- CPU Core 3-Phase-switching voltage regulator with auto-sense from 0.8375V-1.6000V
- Adjustable CPU clock frequency ratio settings (via BIOS)
|
| FAN |
- Total of three 4-pin fan headers
- 3x fans with tachometer monitoring
- Status monitor with firmware/software speed control
- Low noise fan speed control
- Pulse Width Modulated (PWM) fan connector
|
| Temperature |
- Monitoring for CPU and chassis environment
- CPU thermal trip support
- Thermal Monitor (TM2) Support
|
| LED |
- CPU / System Overheat LED
- +3V standby alert LED
- Suspend-state indicator LED
|
| Other Features |
- Chassis intrusion detection
- Chassis intrusion header
|
| |
|
|
RoHS
|
|
| Environmental Spec. |
- Operating Temperature: 10°to 35°C (50°to 95°F)
- Non-operating Temperature: -40°to 70°C (-40°to 158°F)
- Operating Relative Humidity: 8% to 90% (non-condensing)
- Non-operating Relative Humidity: 5 to 95% (non-condensing)
|
| |
|
|
| FCC |
| |
|
|
| |
Part Number |
Qty |
Description |
| PDSBA-Q+ |
MBD-PDSBA-Q+-O |
1 |
PDSBA-Q+ Motherboard |
| Manual(s) |
MNL-0874 |
1 |
Motherboard Manual for PDSBA-Q+ |
| I/O Cables |
CBL-0022L
CBL-041
CBL-0044L |
1
1
4 |
ATX Floppy Cable
4-Port USB 2.0 Cable with Key on 10
SATA Cable (2Ft.) |
| I/O Shield |
MCP-260-00001-00 |
1 |
I/O Shield for PDSBA-Q+ |
|
|
|
 |
|
 |
|
Key Features
Key Features
1. Intel® Core™ 2 Quad, Core™ 2 Duo,
Pentium® D, Pentium 4, & Celeron D
in LGA775Package (FSB 1066/800/533)
2. Intel® Q965 Chipset
3. Up to 8GB Single/Dual Channel DDR2
Unbuffered, DDR2 800/667/533 SDRAM
4. 1x Intel® 82573L Gigabit LAN Port
5. Built-in SATA Controller
4x SATA (3Gbps) Drive Support
6. 1(x16), 1(x4) using (x8) slot, 1(x1)
PCI-E 3x 32-bit 33MHz PCI
7.Realtek ALC883
7.1 Channel HD Audio
8. On-chip Intel GMA 3000 Graphics
9. 10 USB ports (6 Rear USB Ports +
2 Internal Headers(4 ports))
10. Trusted Platform Module
|
|
|
|
|
|
|