|
|
|
|
|
| SYS-1026T-6RF+ | - SuperServer 1026T-6RF+ (Black)
|
| |
| CPU | - Dual 1366-pin LGA Sockets
- Supports up to two Intel® 64-bit Xeon® processor(s) of the same type below:
- Intel® Xeon® Processor X5600/E5600/L5600 Series
(Westmere) 40W - 130W - Intel® Xeon® Processor X5500/E5500/L5500 Series
(Nehalem-EP) 38W - 95W
| QPI | |
| |
| Memory Capacity | - 18x 240-pin DIMM sockets
- Supports up to 288GB 1333 / 1066 / 800MHz DDR3 ECC Registered memory
- Supports up to 48GB 1333 / 1066 / 800MHz DDR3 ECC / Non ECC Unbuffered memory
- Memory Mirroring supported
| Memory Type | - 1333 / 1066 / 800MHz ECC Registered / ECC or Non ECC Unbuffered DDR3 SDRAM 72-bit, 240-pin gold-plated DIMMs
| DIMM Sizes | - 1GB, 2GB, 4GB , 8GB , 16GB
| Memory Voltage | | Error Detection | - Corrects single-bit errors
- Detects double-bit errors (using ECC memory)
- Supports Intel® x4 and x8 Single Device Data Correction (SDDC)
| Note: | This board does not support LRDIMM memory. Please refer to HERE for list of motherboards with LRDIMM support. |
| |
| Chipset | - Intel® 5520 (Tylersburg) chipset
- ICH10R
| SAS | - LSI 6Gbps SAS 2108 w/ Hardware RAID support
- RAID 0, 1, 5, 6, 10, 50, 60 support
- BBU (battery backup) extension kit (optional)
| SATA | - Intel ICH10R SATA 3.0Gbps Controller
- RAID 0, 1, 5, 10 support
| IPMI | - Support for Intelligent Platform Management Interface v.2.0
- IPMI 2.0 with virtual media over LAN and KVM-over-LAN support
- Nuvoton WPCM450 BMC
| Network Controllers | - Intel® 82576 Dual-Port Gigabit Ethernet Controller
- Supports 10BASE-T, 100BASE-TX, and 1000BASE-T, RJ45 output
- Intel® I/OAT 3 support for fast, scaleable, and reliable networking
- VMDq support for better performance of virtualization
- 1x Realtek RTL8201N PHY (dedicated IPMI)
| Graphics | | Super I/O | |
| |
| SAS | - 8x 6Gbps SAS / SATA ports with 2 I-PASS connectors
| Serial ATA | - Six Serial ATA ports
- Six SATA hard drives supported
| LAN | - 2x RJ45 LAN ports
- 1x RJ45 Dedicated IPMI LAN port
| USB | - 2x USB rear ports
- 1x USB on-board
- 2x USB internal headers
- Total 5 USB 2.0 Compliant
| VGA | | Keyboard / Mouse | - PS/2 keyboard and mouse ports
| Serial Port / Header | - 1 Fast UART 16550 serial port
- 1 Fast UART 16550 serial header (Option)
|
| | | |
| Form Factor | | Model | |
| |
| Height | | Width | | Depth | | Gross Weight | | Available Colors | |
| |
| Buttons | - Power On/Off Button
- System Reset Button
- UID Button
| LEDs | - Power LED
- Hard drive activity LED
- 2x Network activity LEDs
- System Overheat LED
- Universal Information (UID) LED
|
| |
| PCI-Expansion | |
| |
| Hot-swap | - 8x 2.5" SAS / SATA Hot-swap drive trays
|
| |
| DVD-ROM | - Slim 8x DVD, 24x CD, DVD-ROM drive
|
| |
| 1U SAS/SATA Backplane w/ SES2 Enclosure Management |
| |
| Fans | | Shroud | |
| |
| 700W/750W Redundant AC-DC high-efficiency power supply with PMBus and I2C | AC Input | - 700W: 100-140 V, 50-60 Hz, 8.5-6 Amp
- 750W: 180-240 V, 60-50 Hz, 5-3.8 Amp
| DC Output +5V standby | | DC Output +12V | - 700W: 58 Amp @ 100-140V
- 750W: 62 Amp @ 180-240V
| With Power Distributor | - +5V: 25 Amp
- +3.3V: 25 Amp
- -12V: 0.6 Amp
| Certification | Gold Certified |
| |
| BIOS Type | - 32Mb SPI Flash EEPROM with AMI® BIOS
| BIOS Features | - Plug and Play (PnP)
- PCI 2.2
- ACPI up to 3.0
- USB Keyboard support
|
| |
| RoHS
| | Environmental Spec. | - Operating Temperature: 10° to 35°C (50° to 95°F)
- Non-operating Temperature: -40° to 70°C (-40° to 158°F)
- Operating Relative Humidity: 8% to 90% (non-condensing)
- Non-operating Relative Humidity: 5 to 95% (non-condensing)
|
|
|
| | Part Number | Qty | Description | Motherboard / Chassis | MBD-X8DTU-6F+ CSE-119TQ-R700UB | 1 1 | Super X8DTU-6F+ Motherboard 1U Chassis | Air Shroud | MCP-310-81901-0B | 1 | Mylar air shroud for SC819, X8DTU+ MB | Backplane | BPN-SAS-113TQ | 1 | Sup 8x2.5" Hot-swap SAS/SATA hdd; SATA con | Cable 1 | CBL-0044L | 1 | SATA CABLE 61CM FLAT S-S PBF. 26AWG flat | Cable 2 | CBL-0287L | 1 | IPASS TO 4 SATA 43/43/33/33CM, W/ 43cm SB, RA ,26AWG | Cable 3 | CBL-0288L | 1 | IPASS TO 4 SATA 70/60/50/50CM, W/ 70CM SB, RA ,30AWG | Adapter 1 | CDM-SATA | 1 | mini-SATA to SATA adapter for slim DVD | Peripheral Drive *** | DVM-PNSC-DVD-SBT1 | 1 | BLACK PANASONIC SLIM DVD ROM SATA DRIVE | Peripheral Drive *** | DVM-TEAC-DVD-SBT2 | 1 | BLACK TEAC SLIM DVD ROM SATA DRIVE ROHS | CD | CDR-X8 | 1 | For X8 series | Riser Card | RSC-R1UU-2E8 | 1 | RISER CARD RSC-R1UU-2E8 | Riser Card | RSC-R1UU-E8R+ | 1 | RSC-R1UU-E8R+ REV 1.00, PBF | Heatsink / Retention | SNK-P0037P | 2 | 1U PASSIVE CPU HS FOR INTEL LGA1366 (HTP) | Power Supply | PWS-703P-1R | 2 | 1U REDUNDANT PWS 50MM W PMBUS GOLD EFFICIENCY 50MM | Power Distributor | PDB-PT819-8824 | 1 | SC819 24pin redundant PDB | Cable 4 | CBL-0335L | 1 | FRONT CTL CABLE 20 PIN TO 20 PIN W/TUBE,70CM,PBF. 28AWG | Fan 1 | FAN-0101L4 | 5 | 40x56,4 Pin PWM,Primary for SC809,111, Sec.for SC816,819,808 | Drive Tray(s) | MCP-220-00047-0B | 8 | Black gen 3rd hot-swap 2.5inch HDD tray | Mounting Rails | MCP-290-00062-0N | 1 | Rail set, quick/quick, default for 1U 17.2 |
|
| | | |
| | Part Number | Qty | Description | BBU (Battery Backup Unit) | BTR-0018L-0000-LSI | - | Battery Backup for SAS 2108 (Need Extension Kit BTR-0018L-kit to be installed) | BBU (Battery Backup Unit) Extension Kit | BTR-0018L-kit | - | Battery Backup Extension Kit (Need to be installed at a 2.5" HDD location) | UIO Controller Card(s) | - | - | Please refer to our UIO Add-on Card Table |
|
|
|
|
|
|
|
|
|
Key Features
1. Intel® Xeon® processor 5600/5500 series, with QPI up to 6.4 GT/s2. 288GB** DDR3 1333/ 1066/ 800MHz ECC Registered DIMM / 48GB Unbuffered DIMM3. Left Slot (Full-height / Full-length): 2 (x8) PCI-E 2.0 slots4. Right Slot (Low-Profile - 5.5" depth): 1 (x4) PCI-E 2.0 (in x8 slot)5. LSI 2108 8-Port 6Gbps SAS Controller; RAID 0, 1, 5, 6, 10, 50, 606. Intel® 82576 Dual-Port Gigabit Ethernet Controller7. 8 x 2.5" Hot-swap SAS/SATA Drives, For Customizable Storage8. 700W Gold-Level Redundant Power Supply
|
|
|
|
|
|
|