 | |
 | | SSG-6047R-E1R72L2K | - SuperServer 6047R-E1R72L2K (Black)
|
| | |
| | CPU | - Dual Socket R (LGA 2011)
- Intel® Xeon® processor E5-2600
and E5-2600 v2 family†
(up to 135W TDP *)
* Please contact your Supermicro sales representative for additional details | | Note | † BIOS version 3.0 or above is required | | Cache | | | System Bus | |
| | |
| | Memory Capacity | - 16x 240-pin DDR3 DIMM sockets
- Up to 1TB DDR3 ECC LRDIMM
- Up to 512GB DDR3 ECC Registered memory (RDIMM)
- Up to 128GB DDR3 ECC Un-Buffered memory (UDIMM)
| | Memory Type | - 1866/1600/1333/1066/800MHz ECC DDR3 SDRAM 72-bit, 240-pin gold-plated DIMMs
| | DIMM Sizes | - 32GB, 16GB, 8GB, 4GB, 2GB, 1GB
| | Memory Voltage | | | Error Detection | - Corrects single-bit errors
- Detects double-bit errors (using ECC memory)
|
| | |
| | Chipset | | | SATA | - SATA 2.0 3Gbps with RAID 0, 1, 5, 10
- SATA 3.0 6Gbps with RAID 0, 1, 5, 10
| | SAS | - SAS2 via LSI 2308; IT Mode/Pass-through
| | IPMI | - Support for Intelligent Platform Management Interface v.2.0
- IPMI 2.0 with virtual media over LAN and KVM-over-LAN support
- Renesas SH7757 BMC
| | Network Controllers | - Intel® i350 Gigabit Ethernet
- Virtual Machine Device Queues reduce I/O overhead
- Supports 10BASE-T, 100BASE-TX, and 1000BASE-T, RJ45 output
- 1x Realtek RTL8201N PHY (dedicated IPMI)
| | Graphics | - G200 (Renesas SH7757 BMC w/ graphic controller)
| | Super I/O | |
| | |
| | Serial ATA | - 2x SATA 3.0 ports (6Gbps)
- 4x SATA 2.0 ports (3Gbps)
| | SAS | | | LAN | - 4x RJ45 Gigabit Ethernet LAN ports
- 1x RJ45 Dedicated IPMI LAN port
| | USB | - 9x USB 2.0 ports total
(4 rear + 4 via header + 1 Type A)
| | VGA | | | Serial Port / Header | - 1x Fast UART 16550 port / 1 Header
|
| | | |
| | Form Factor | | | Model | - CSE-847DTS-R000LP
(only sold as complete system)
|
| | |
| | Width | | | Height | | | Depth | | | Weight Unpopulated | - Net Weight: 67 lbs (30.4 kg)
- Gross Weight: 104 lbs (47.2 kg)
| | Available Colors | |
| | |
| | Buttons | - Power On/Off button
- System Reset button
| | LEDs | - Power status LED
- Hard drive activity LED
- 2x Network activity LEDs
- System Overheat LED
- Power fail LED
|
| | |
| | PCI-Express | - 4x PCI-E 3.0 x8 slots (Low-profile)
|
| | |
| | Hot-swap | - 72x 3.5" SAS2/SATA3 in 36x Hot-swap drive bays (2x HDD per bay w/LEDs for each drive)
- Double-sided: 24 front + 12 rear HDD Bays
| | Fixed | - Internal Drive Bracket suppports 2x 2.5" drive bays
|
| | |
| | SAS2 / SATA3 single expander per backplane |
| | |
| | Fans | - 7x 9cm hot-swap cooling fans
- Redundant cooling
|
| | |
| 2000W redundant power supply | | AC Input | - 1100W Output @ 100-120V, 12.7-10.5A, 50-60Hz
- 1400W Output @ 120-140V, 13.5-11.5A, 50-60Hz
- 1800W Output @ 200-220V, 10.0-9.5A, 50-60Hz
- 1980W Output @ 220-230V, 10.0-9.8A, 50-60Hz
- 2000W Output @ 230-240V, 10.0-9.8A, 50-60Hz
| | DC Output | - 1100W: +12V/91.7A; +5Vsb/4A
- 1400W: +12V/116.7A, +5Vsb/4A
- 1800W: +12V/150.0A; +5Vsb/4A
- 1980W: +12V/165.0A; +5Vsb/4A
- 2000W: +12V/166.7A; +5Vsb/4A
|
| | |
| | BIOS Type | - 128Mb SPI Flash EEPROM with AMI BIOS
| | BIOS Features | - Plug and Play (PnP)
- APM 1.2
- PCI 2.2
- ACPI 1.0 / 2.0
- USB Keyboard support
- SMBIOS 2.3
- UEFI
|
| | |
| RoHS
| | | Environmental Spec. | - Operating Temperature:
10°C to 35°C (50°F to 95°F) - Non-operating Temperature:
-40°C to 70°C (-40°F to 158°F) - Operating Relative Humidity:
8% to 90% (non-condensing) - Non-operating Relative Humidity:
5% to 95% (non-condensing)
|
|